// This file is a config template, and can be copied to config.h.
// Please don't save any important password in this template.
// IMPORTANT: Parameters defined in config.h are only default values, and are applied if:
// * the ampel is flashed for the first time
// * or 'reset_config' command is called
// * or AMPEL_CONFIG_VERSION has been changed.
// Once those default values have been applied, uploading the firmware with a modified config.h will not update the ampel configuration!
// Every parameter can be modified and saved later via the web-config.
// Some of those parameters can also be modified via commands in the Serial monitor :
// e.g. 'wifi 0' to turn WiFi off, or 'csv 60' to log data in csv every minute.
/***
* AMPEL
*/
...
...
@@ -167,6 +163,7 @@
// 3) It has been tested with "TTGO ESP32 SX1276 LoRa 868" and will only work with an ESP32 + LoRa modem
// 4) In order to use LoRaWAN, a gateway should be close to the co2ampel, and an account, an application and a device should be registered,
// e.g. on https://www.thethingsindustries.com/docs/integrations/
// with "Europe 863-870 MHz (SF9 for RX2 - recommended)", "MAC v1.0.3"
// 5) The corresponding keys should be defined in LORAWAN_DEVICE_EUI, LORAWAN_APPLICATION_EUI and LORAWAN_APPLICATION_KEY
// How often should measurements be sent over LoRaWAN?
# define LORAWAN_SENDING_INTERVAL 300 // [s] This value should not be too low. See https://www.thethingsnetwork.org/docs/lorawan/duty-cycle.html#maximum-duty-cycle
