Commit 02e6f0b0 authored by Eric Duminil's avatar Eric Duminil
Browse files

Updated README

parent 8b16d137
Pipeline #5869 passed with stage
in 2 minutes and 37 seconds
......@@ -99,11 +99,12 @@ make upload board=esp32 && make monitor # For ESP32
In Arduino IDE *Serial Monitor* or PlatformIO *Monitor*, type `help` + <kbd>Enter</kbd> in order to list the available commands:
* `ap!` (Forces access point mode).
* `auto_calibrate 0/1` (Disables/enables autocalibration).
* `calibrate` (Starts calibration process).
* `calibrate 600` (Starts calibration process, to given ppm).
* `calibrate` (Starts calibration process).
* `calibrate! 600` (Calibrates right now, to given ppm).
* `co2 1500` (Sets CO<sub>2</sub> level, for debugging purposes).
* `co2 1500` (Sets CO<sub>2</sub> level, for debugging).
* `color 0xFF0015` (Shows color, specified as RGB, for debugging).
* `csv 60` (Sets CSV writing interval, in s).
* `format_filesystem` (Deletes the whole filesystem).
......@@ -112,12 +113,17 @@ In Arduino IDE *Serial Monitor* or PlatformIO *Monitor*, type `help` + <kbd>Ente
* `local_ip` (Displays local IP and current SSID).
* `lora 300` (Sets LoRaWAN sending interval, in s).
* `mqtt 60` (Sets MQTT sending interval, in s).
* `pwd abc` (Sets WiFi password to 'abc').
* `reset` (Restarts the ESP).
* `reset_config` (Resets the complete IotWeb config).
* `reset_scd` (Resets SCD30).
* `save_config` (Saves the config to EEPROM).
* `send_local_ip` (Sends local IP and SSID via MQTT. Can be useful to find sensor).
* `set_time 1618829570` (Sets time to the given UNIX time).
* `show_csv` (Displays the complete CSV file on Serial).
* `ssid name` (Sets SSID to 'name').
* `timer 30` (Sets measurement interval, in s).
* `wifi 0/1` (Turns Wifi on/off).
* `wifi_scan` (Scans available WiFi networks).
The commands can be sent via the Serial interface, from the webpage or via MQTT.
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment