// NOTE: Every parameter can be modified and saved later via the web-config.
// Some of those parameters can also be modified via commands in the Serial monitor :
// e.g. 'wifi 0' to turn WiFi off, or 'csv 60' to log data in csv every minute.
/***
* AMPEL
*/
...
...
@@ -27,12 +28,17 @@
// If left empty, the name will be ESPxxxxxx, where xxxxxx represent the last half of the MAC address.
# define AMPEL_NAME ""
// This password will be used for Access Point (without username), and for web-server available at http://local_ip with user 'admin', without quotes.
// If left empty, the password will have to be set during the first configuration, via access point.
// In order to be set successfully, it should have at least 8 characters.
# define AMPEL_PASSWORD ""
/**
* SERVICES
*/
// Define the default for corresponding services. They can be enabled/disabled later in the web-config.
# define AMPEL_WIFI true // Should ESP connect to WiFi? It allows the Ampel to get time froman NTP server.
# define AMPEL_WIFI true // Should ESP connect to WiFi? Web configuration will not be available when set to false. Use "wifi 1" command to set to true.
# define AMPEL_MQTT true // Should data be sent over MQTT? (AMPEL_WIFI should be enabled too)
# define AMPEL_CSV true // Should data be logged as CSV, on the ESP flash memory?
# define AMPEL_LORAWAN false // Should data be sent over LoRaWAN? (Requires ESP32 + LoRa modem, and "MCCI LoRaWAN LMIC library")
...
...
@@ -97,16 +103,6 @@
// How many LEDs in the ring? 12 and 16 are currently supported. If undefined, 12 is used as default.
# define LED_COUNT 12
/**
* AMPEL PASSWORD
* will be used for Access Point (without username), and for web-server available at http://local_ip
* with user 'admin', without quotes.
*/
// If left empty, the password will be set during the first configuration, via access point.
// In order to be set successfully, it should have at least 8 characters.
